Tips & Tricks

Assemble a Tiered Tower

image22

Start from the BOTTOM

Thread screw through large metal washer

Poke through bottom plate

Use Screwdriver to tighten (don't overdo it!)

Add white washer (if thin plate)

Adhere rod

Add white washer (if thin plate)

Place next plate

Add white washer (if thin plate)

Adhere rod (or Finial if only 2-Tier)

Add white washer (if thin plate)

Place top plate (if 3-Tier)

Add white washer (if thin plate)

Adhere Finial to complete tower assembly

Take screwdriver and tighten again from the bottom, adjust top screws to ensure a straight tower


*White washers are only necessary to fill the gaps on thin plates.  They are not necessary on some towers.


Disassemble a Tiered Tower

image23

Start from the TOP

Unscrew Finial

Remove any washers

Remove plate

Remove any washers

Remove rod

Remove any washers

Remove plate

Remove any washers

Remove rod

Remove any washers

remove plate

remove screw and metal washer

place all pieces in "Hardware Bag"

Request Replacement Parts

image24

Lost a piece of hardware? No problem.  Email me and I will mail replacements to you at no cost, or minimal cost, depending on parts needed.

Caring for Sterling Plate

image25

Cleaning Silver is so easy these days.  I use FLITZ Metal Polish.  You can order it on AMAZON.  It is environmentally friendly and works super well.  Once cleaned, wrap silver tightly in SARAN WRAP.  This will keep the piece free of oxidation for months/years.